ASTM A1011/A1011M, Revision 18A – Standard Specification for Steel, Sheet and Strip, Hot-Rolled, Carbon, Structural, High- Strength Low-Alloy, High-Strength Low-Alloy with Improved Formability, and Ultra-High Strength

ASTM A1011 specification covers hot-rolled, carbon, structural, high-strength low-alloy, high-strength low-alloy with improved formability, and ultra-high strength steel sheet and strip, in coils and cut lengths.

Hot rolled steel sheet and strip is available in the designations as listed in 4.1.

This specification is not applicable to the steel covered by Specification A635/A635M.

The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

General Product Information:

Revision	Revision 18A
Document Type	PDF
Document Language	English
Pages	9
Publisher	ASTM International (ASTM)
Status	Current

ASTM Volume

01.03: Steel–Plate, Sheet, Strip, Wire; Stainless Steel Bar

Under the heading of steel plate, sheet, and strip, this volume covers specifications that stress mechanical property requirements and applications. The majority of them have been adopted by the Department of Defense. Also featured are specifications that detail the properties of assorted types of steel wire and industrial sizing screens.